Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
apps:spaces [2017/11/10 09:25] – external edit 127.0.0.1apps:spaces [2020/05/20 15:26] – created the Spaces page and put in some initial information enviadmin
Line 1: Line 1:
 {{:apps:icon_spaces.png? nolink 150|}} {{:apps:icon_spaces.png? nolink 150|}}
 ====== Spaces====== ====== Spaces======
 +
 +The ENVI-met Suite program Spaces makes it possible to digitize your raster-based model area directly in the program or optimize the model area previously created in Monde or other programs. 
 +
 + ===== Initial Settings=====
 +
 +As a first step after starting the program, you should, similar to most other ENVI-met Suite programs, pick the project will be working in. This way, the project-own materials will be available if you are using a project database. 
 +
 +When creating a new area, you are first prompted to set your **Model Location**. This is important as the local radiation during the simulation is calculated depending on the position on the earth. Please make sure to correctly adapt this setting.
 +
 +The **Model Geometry** allows you to define the amount x, y, and z grids and their respective resolutions. It also gives you the option to use //Splitting// and/or //Telescoping//, two options which are further described [[kb:verticalgrid|here]]. Splitting allows for a better resolution towards the ground of the simulation area, leading to more accurate results here. Telescoping makes it possible to reach a higher overall height of the model area without adding too many z grids. The telescoping should only start at a height higher or equal to your highest building, so that the buildings are still gridded correctly. 
 +
 +
 +
 +
 +
 +